Follow these easy steps to get your AEG FAVORIT 60870 Dishwasher up and running in no time.
Inspect the dishwasher for any transport damage. Do not connect the appliance if it is damaged. Contact your retailer in case of damage.
Place the dishwasher on a firm, level floor. Adjust the threaded feet with a screwdriver to ensure stability and to match the height of surrounding units.
Connect the dishwasher to a cold water supply. Ensure that the safety devices preventing wash water from returning into the drinking water system are properly installed.
Ensure the appliance is earthed. Check that the electricity supply voltage matches the rating plate. If permanently wired, remove the fuse to isolate the dishwasher from the mains.
Set the water softener to the required water hardness level to prevent scale deposits. Fill the water softener with water and special salt.
Fill the rinse aid dispenser located inside the dishwasher door to ensure optimal drying results.
Fill the salt container with water and special salt before first use. Open the container by turning the lid anticlockwise, then add the water and salt.
Ensure the salt and rinse aid levels are adequate before loading dishes. Refill as necessary if the indicators are illuminated.
Before loading, remove scraps of food from dishes. Avoid washing sponges or any absorbent materials in the dishwasher.
Choose a wash programme suitable for the load's soiling level. Press the relevant programme button on the control panel.
Turn on the water tap fully, close the dishwasher door, and press the ON/OFF button. The LED will illuminate, indicating readiness. Select the desired programme to start the wash cycle.